Rope care · Climb3D

R2

RopeReset

Your rope, ready for the next route.

R2 helps reduce accumulated twist as the rope passes through a guided path. A simple step when you pack up after climbing.

Buy R2 on Amazon See how it works

€25 · Available on Amazon

R2 RopeReset with climbing rope, showing its IN and OUT openings
Rope running through the R2 channel during a demonstration

In use

One pass. Less twist.

Hold R2 and pull the unloaded rope through slowly and steadily. The channel keeps its path visible so you can check the entry and exit before continuing.

Read instructions and safety →

The details

A clear path for your rope.

IN and OUT markings on the back of R2

From IN to OUT

The markings on the back show where the rope enters and exits. Check the path before pulling.

R2 held in place while the rope is pulled through

Hold it your way

Hold R2 in one hand or secure it with a cord through the upper holes while feeding the rope through.

Compatible rope
9–11 mm
Height
61 mm
Approximate weight
≈ 60 g

One 3D printed PLA piece. Use only with a free, unloaded rope.

R2 · RopeReset

Get your rope ready for what comes next.

Get R2 for €25 on Amazon. Read the full setup and safety guide on this site before use.

Buy R2 on Amazon Read instructions and safety

Rope care accessory. Not PPE or a belay device. Never use under load or while climbing.